Finish and secure adjoining panel edges at inside corners with the EPIC QT Stainless Steel Panel Retainer Trim. Its 90-degree profile covers the corner joint and overlaps panel edges for a clean, professional appearance.

Made from 18-gauge Type 304 stainless steel with a #4 brushed finish, this trim combines rigidity and corrosion resistance with a surface that complements stainless steel panels and appliances. Each leg measures 2 inches wide, providing coverage on both sides of the corner along the full 48-inch length.

Choose with pre-punched holes or without holes to suit your installation. The pre-punched version features eight 1/4-inch-diameter mounting holes—four per leg, spaced approximately 15 inches apart, with end holes approximately 1-1/2 inches from each end. Plastic anchors and #10 × 1-1/2-inch stainless steel screws are included.

Suitable for wall panels, backsplashes, equipment enclosures, and architectural cladding in commercial and residential settings.

Product Features

• 90° inside corner profile: Covers the joint where two perpendicular panel surfaces meet.
• Panel retention: Overlaps adjoining panel edges to help hold them in position when properly fastened.
• Type 304 stainless steel: Durable, corrosion-resistant construction.
• #4 brushed finish: Coordinates with stainless steel wall panels, appliances, and equipment.
• Two mounting options: Available with pre-punched holes or without holes.
• Included mounting hardware: Plastic anchors and #10 × 1-1/2-inch stainless steel screws.

Specifications

Installation

Position the trim over the adjoining panel edges at the inside corner and confirm fit before securing. For the pre-punched version, use the mounting holes to mark the fastening locations. The version without holes allows you to drill mounting holes where needed for your installation.

Use the included hardware where appropriate for the supporting surface. Other substrates may require different anchors or fasteners.

Care and Maintenance

Clean with mild soap and water using a soft cloth. Wipe in the direction of the brushed grain to preserve the finish. Avoid abrasive cleaners, steel wool, and chlorine bleach.